07.05.2011, 00:20
Not a lot was done today, just the little control box on the starboard side:
And the starboard exit, installed after this photo was taken:
Note the doubled door and control pad. I didn't glaze the windows since there's no interior to show off, but I cut the windows' images out and inset them a bit.
Here's the inside showing the inset windows glued in place:
I don't seem to be getting any better at touching up the edges. <G>
Edit: I just installed the port exit. No photo, but it did turn out somewhat prettier than the starboard one. :-)
And the starboard exit, installed after this photo was taken:
Note the doubled door and control pad. I didn't glaze the windows since there's no interior to show off, but I cut the windows' images out and inset them a bit.
Here's the inside showing the inset windows glued in place:
I don't seem to be getting any better at touching up the edges. <G>
Edit: I just installed the port exit. No photo, but it did turn out somewhat prettier than the starboard one. :-)